This paper is aimed at investigating the nitric oxide (NO) removal using dielectric barrier discharges (DBD) in a multi-rod reactor stressed by ac and pulse high voltages. The effects of various parameters (the voltage amplitude, frequency, gas flow rate, use of the γ-alumina pellets and the voltage type) on the discharge power and NO removal rate have been studied experimentally in the multi-rod DBD reactor. When the reactor was filled with γ-alumina pellets, improvement in NO removal rate was observed. The pulse voltage gives higher NO removal rate in comparison with ac voltage at the same energy density. Records of the discharge photograph and the emission intensity have been made at varying voltage amplitude, frequency, and gas flow rate. The records confirm the dependency of the discharge power on these parameters.

This study investigates experimentally the thermal perception of indoor environment for evaluating the ability of radiant panel heaters to produce thermal comfort for space occupants as well as the energy consumption in comparison with conventional portable natural convective heaters. The thermal perception results show that, compared with conventional convection heater, a radiantly heated office room maintains a lower ambient air temperature while providing equal levels of thermal perception on the thermal dummy head as the convective heater and saves up to 39.1% of the energy consumption per day. However, for human subjects’ vote experiments, the results show that for an environmentally controlled test room at outdoor environment temperatures of 0°C and 5°C, using two radiant panel heaters with a total capacity of 580 W leads to a better comfort sensation than the conventional portable natural convective heater with a 670Wcapacity, with an energy saving of about 13.4%. In addition, for an outdoor environment temperature of 10°C, using one radiant panel heater with a capacity of 290 W leads to a better comfort sensation than the conventional convection heater with a 670Wcapacity, with an energy saving of about 56.7%. From the analytical results, it is found that distributing the radiant panel heater inside the office

This study investigates experimentally the thermal perception of indoor environment for evaluating the ability of radiant panel heaters to produce thermal comfort for space occupants as well as the energy consumption in comparison with conventional portable natural convective heaters. The thermal perception results show that, compared with conventional convection heater, a radiantly heated office room maintains a lower ambient air temperature while providing equal levels of thermal perception on the thermal dummy head as the convective heater and saves up to 39.1% of the energy consumption per day. However, for human subjects’ vote experiments, the results show that for an environmentally controlled test room at outdoor environment temperatures of 0°C and 5°C, using two radiant panel heaters with a total capacity of 580 W leads to a better comfort sensation than the conventional portable natural convective heater with a 670Wcapacity, with an energy saving of about 13.4%. In addition, for an outdoor environment temperature of 10°C, using one radiant panel heater with a capacity of 290 W leads to a better comfort sensation than the conventional convection heater with a 670Wcapacity, with an energy saving of about 56.7%. From the analytical results, it is found that distributing the radiant panel heater inside the office

In this study, design of a compact plates-and-frames absorber possessing a hydrophobic microporous membrane contactor at the aqueous solution–water vapor interface is performed analytically. The absorber is a component of a 5 kW cooling capacity single-effect lithium bromide–water absorption chiller that incorporates a hot water thermally driven generator and a water-cooled absorber and condenser. Good agreement prevailed for the analytically evaluated water vapor mass transfer flux and aqueous solution outlet temperature when compared with measured values at similar operating conditions. At design point conditions, the main design parameters obtained are a membrane contactor area of 6.06 m2, a ratio of the mass transfer area to absorber net volume (Am=Vnet) of 130.1(m2/m3), and ratio of the membrane area (mass transfer area) in this design configuration to the area required for heat transfer is 1.162, respectively. The results clearly indicate that the aqueous solution channel thickness is the most significant design parameter that affects the absorber size compactness; the thinner the thickness of the solution channel, the higher the ratio (Am=Vnet ). The results also show the countercurrent refrigerant flow with the aqueous solution has positive effects on the absorber size compactness.

Characteristics of mean droplet size of spray produced by spinning disk atomizers were experimentally investigated. The phase-doppler particle analyzer (PDPA) was used to measure the droplet size of water spray in the downstream distance along the spray trajectory. Effects of various operating conditions on the mean diameter had been studied. The studied variables were: the rotational speed in the range of 838 to 1677 rad/s (8,000–16,000 rpm), the liquid flow rate in the range of 0.56 to 2.8  106 m3/s (2–10 L/h), the disk diameter in the range of 0.04 to 0.12 m, and the downstream tangential distance along the spray trajectory of up to 0. 24 m. The Sauter mean diameter (d32) was used to represent the mean of generated spray droplet sizes. The results indicated that the Sauter mean diameter can be correlated with dimensionless groups, such as the Reynolds number, Weber number, flow coefficient, and the ratio of downstream distance to disk diameter. Based on this correlation, it was found that the Sauter mean diameter (d32) increases as the downstream tangential distance, and liquid flow rate increase. Similarly, a decrease of rotational speed and disk diameter results in an increase in the Sauter mean diameter (d32). A comparison between the developed correlation and correlations obtained by other researchers has been presented and discussed in detail. [DOI: 10.1115/1.4006819]